Norton® SPEEDGRIP™ 04616 Structural Adhesive, 220 mL, Liquid, Black, 1.288 at 70 deg F, 7 min Application

Description

Here are the steps on how to use Norton SpeedGrip 04616 Structural Adhesive:

1. Prepare the surfaces to be bonded. Remove any dirt, grease, or oil from the surfaces with a solvent or degreaser.
2. Apply a thin bead of adhesive to one surface.
3. Apply a thin bead of adhesive to the other surface.
4. Press the two surfaces together and hold for 5 minutes.
5. Allow the adhesive to cure for 7 minutes.

Here are some tips for using Norton SpeedGrip 04616 Structural Adhesive:

• Use a clean, dry surface to apply the adhesive.
• Apply a thin bead of adhesive to each surface.
• Press the two surfaces together firmly and hold for 5 minutes.
• Allow the adhesive to cure for 7 minutes before applying any pressure to the bonded surfaces.
• Use a sharp knife or razor blade to trim any excess adhesive.
• Sand the bonded surfaces with a fine-grit sandpaper to achieve a smooth finish.
• Apply a primer or paint to the bonded surfaces for a better finish.

Norton SpeedGrip 04616 Structural Adhesive is a two-part urethane adhesive that is designed for bonding plastic and metal surfaces. It is a fast-curing adhesive that is resistant to water and heat. It is also a strong adhesive that can withstand a lot of wear and tear.